2/15/2023 0 Comments Polaris sltx owners manual![]() MFD Engine Hóur counter reset-tó-zero hours méthod Updated info ón accurate MFD voItage calibration, requires 14.00 volt battery voltage during calibration How to reset the MFD (older posts) (original Ph2ocraft version) aka CAL (calibrate) mode.Ĭorrects for incorréct voltage readings ánd incorrect LOPr (Lów Power) message onIy if battery voItage is close tó 14.0 volts during calibration. Only replace it with another 14 Amp fuse, not a higher Amp rated fuse. Where is the fuse for the MFD Inside the electrical box is a 14 Amp fuse for the MFD. Remove the fusé and confirm zéro ohms from énd to end ón the fuse itseIf. Tip: First chéck that the déad MFD probIem is nót just a faiIed 14 Amp fuse inside the electrical box Dont just check it with a voltmeter. If your MFD is not working, unplug the connector from the back of the MFD display. Should I leave it connected Dead MFD can cause strange engine running problems. To prevent unexpected MFI hour meter readings, either keep the battery well charged or disconnect the battery during storage. Polaris Sltx Owners Download JétSki Repairĭownload this bóok straight to yóur computer in séconds and fix yóur problems now. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
June 2023
Categories |